With a diode laser, you can also cut the hardboard, and plywood and make amazing crafts based on the designs that you have.Ĭreality’s laser modules are the diode laser with a power variety of 1.6 watts, 5 watts, and 10 watts. CO2 lasers are used to cut wood, stone, acrylic, plywood, MDF, glass, and other thicker materials.ĭiode lasers are the least powerful compared to both CO2 & fiber lasers which are mainly used to engrave at around 1 mm to 10 mm depth. Fiber lasers range from 2000 watts to 4000 watts which are more than 100% more powerful than the CO2 laser cutters.ĬO2 lasers cut different materials with the help of gas and electricity that ranges from 40 watts to 300 watts. Among them, Fiber lasers are the most expensive and used for heavier materials such as thick metal, copper, stainless steel, and alloy. There are mainly three types of laser cutters & engravers – Diode laser, CO2 laser & Fiber laser. Common problems of converting a 3d printer into a laser engraver.Is it wise to convert a 3d printer into a laser engraver?.

Does the Creality laser module generate fume & Noise?.How to convert Creality 3d printer into Laser Engraver?.What types of laser modules has Creality launched?.Single layer, single laser power is easy in Luban. It is so quick to set up and start burning compared to InkScape/Luban assuming you are doing ANY multi-layer burn. If you line up wood right along the X,Y edges in lower left every time, you can replicate easily and even resume jobs after moving wood. If you use “Get Position” button on move tab, it should say 0,0 when you are at origin. The epiphany was when i realized I had to restart LlightBurn right after zeroing on the SM2 console. At this point if you click Get Position in the Move tab, it should say 0,0. Once you have origin on SN2 perfect using console, connect USB cable and START LightBurn. The rest of the work from here is in LightBurn. I fire the laser at 1% and try to get dead center on allen bolt head in lower left corner of plate EXACT every time i set Work Origin on SN2 here. Set work origin to lower left corner using jog.

The 'trick' is to use the SM2 to find calibration for the thickness of wood you are using and to set work origin. So, follow directions for connecting to Lightburn on forum. I couldn’t get my head around how easy it is. I JUST learned InkScape and moving to LightBurn was TOO easy. I mashed the laser into the plate while learning but it has been so worth it.

Snapmaker lightburn